Leave it for 24 hours and then move on to the next step. Fold flesh sides together again, roll and place in the five-gallon bucket. Then take it out, shake the old salt off, and reapply fresh. The bucket is crucial as it will help catch any moisture that leaks out of the hide. Fold flesh side together, and then roll it up, and put it in a five-gallon bucket. Pour the salt liberally over the flesh side of the hide until it’s completely covered. I buy the small canisters that are 1/2 lb each), which only costs a few bucks from any store.
You’ll need a few pounds of table salt (any brand will work. Use a sharp knife to get the last few bits off before proceeding to the next step. You’ll want to be particularly careful around the edges of the hide as it’s easy to miss small pieces. All of the flesh-colored pieces should be gone, leaving this side of the deer hide smooth. Make sure the flesh side is clean and white before proceeding to the next step. Your deer hide should be completely clean without any remnants of meat. It can be a little messy, so you’ll want to wear safety glasses. It’s also important to keep the stream of water moving across the hide fairly quickly as holding the water in one spot will result in a hole. I recommend testing the pressure on a corner piece of the hide to ensure that it’s not going to rip.
You’ll need one that is 1800 PSI to be able to peel the flesh back, and most household pressure washers will work for this project. Take the pressure washer, and simply pressure wash the flesh off of the hide. Beka Garrisĭrape the hide flesh side up over a hard surface such as a large plastic drum, or tack it to a piece of plywood. If you don’t own one, check your local hardware store for a rental. A pressure washer is the fastest and easiest way to flesh a deer hide. If you’re working with a fresh deer hide, proceed as follows. If your hide is in the freezer, you’ll want to make sure it’s thawed completely before starting the fleshing process. But never fear, there is a more modern solution. If you’ve ever fleshed a hide by hand before, you’ll know it can be a tedious task.
#Tanning rabbit hides easy skin
Fleshing (Removing All Flesh From the Skin Side of the Hide.) Though that is definitely still one way to tan a deer hide, there are easier ways that are just as efficient and cheaper than sending it to a tannery.ġ. When most people hear of tanning a deer hide, it makes them automatically think of the traditional method using brains.
0 kommentar(er)
